Support my habit, Get cool Stuff

Monday, October 7, 2013

Testing 3D printed dice fairness

It's been a question on my mind for a while whether a 3D printed die can be fair and balanced? The reality is that the dice you buy aren't necessarily fair, so making a 3D printed dice fair could actually be an advantage. For a while I wanted to build a clever machine to automatically test dice, but that's been a project I never had time to explore. Finally I decided to print a bunch of dice and just roll away.

At first I printed a 4 dual colored dice, 20% infill and 2 shells. Not knowing there was a proper way to go about this I just stared rolling and recording until I felt a bias turn up. After collecting over 200 data points it seemed to me that there was a bias towards the low numbers for some reason, so I decided that I should try a single color dice.

Next I tried 6 copies of the customizable dice, 20% infill, 2 shells. I wanted this one to work, and the bias seemed somewhat less.

However I theorized that 100% infill would be better. So I printed 5 copies 100% infilled. Only the bias seemed to get worse, 1 hardly ever came up. So I inspected the dice and found discovered there was a seam running up the corner between the 1 and 4 side. Other slicers try to negate this by jittering where they start and end perimeter loops. MakerWare thinks they got rid of the seam so they done, which means when they're wrong you get a zipper up one side. 
I cut off the zipper and tried again. The bias seems to have shifted, but continued to persist. Infact the 20% infill dice still seemed less biased. I worried that the infill wasn't consistent between copies, making each of them mask the biases of the others, which was not the point of multiple copies.

Finally I did some research and discovered that there is a prescribed method for these thing that involves only 30 rolls and does not involve "seems like" analysis. I also discovered that commercial dice aren't always fair and that the rounder dice make imbalance more pronounced. With this in mind I threw away the old data, sought out some flatter dice (for which there aren't many on thingiverse) and started to properly gather data, which I will report on in part 2.

3 comments:

  1. Hey Joseph. I'll see if I can find the link but somebody did this on Kickstarter about a year ago. If I remember correctly they mathematically figured out how deep the indentations needed to be on each side so that the die was weighted equelly on all six sides and then had them milled in titanium. I'm pretty sure they got the funding so should be able to find it.

    ReplyDelete
    Replies
    1. Doesn't mean it'll work in plastic, in layers, or with infill. Not that it would be bad to research it, but just not sure how much of it will carry over. There's already a "fair" die on Thingiverse that, as it turns out, isn't.

      i have high hopes for the flatter dice.

      Delete
  2. This comment has been removed by a blog administrator.

    ReplyDelete

Note: Only a member of this blog may post a comment.